Best way to cut a closet maid rack

[miserkris]

Hello what's the best way to quickly cut ClosetMaid rack? I want to cut into two pieces

Do I use a Dremel or just a chisel with a hammer?

I will use it as a rack to hang my lights over my 75 gallon thanks

[Sk8r]

A dremel might not be strong enough and might scar it, ditto the chisel. My recommendation is a hacksaw with a 'metal' blade, done quite gently and accurately. You can also get a little deal that's basically a handle with a stubby hacksaw type blade that slips into tight areas. None of these is pricey.

[gffpm1247]

Bolt cutters

Sent from my XT1585 using Tapatalk

[A sea K]

Bolt cutters are quick and easy, high speed cut-off wheel (dremel on steroids) is a bit more complicated (requires special tools) but makes a cleaner cut. Hacksaw and cold chisel are both easily doable as well yet slightly more labor intensive.
Just use whatever you may have available as any of the above will work.

[homer1475]

I used my dremel and a cutoff wheel. Took a little longer then perhaps a hacksaw, but much less labor intensive.

[miserkris]

Hacksaw works perfect....just longer time....Thanks all

[ladynavyvet]

Good old side grinder.

Sent from my SM-N920V using Tapatalk

[neoh74]

I use the back cutting side of vice grips

[jmad147]

Small bolt cutters,quick and easy then followed up with a grinder to smooth out edges.

[ericarenee]

Bolt cutters all the way...

snap snap...

[Devolver]

bolt cutters