PDA

View Full Version : Finally my reefer is here now to design the hard plumbing for a spray bar and into th


Drewy1988
06/20/2017, 09:01 AM
https://uploads.tapatalk-cdn.com/20170620/8135cb396d3200cb097600256a0b4fb4.jpghttps://uploads.tapatalk-cdn.com/20170620/a2258d3d6d8ea82dfbe4eb505f15414a.jpg

Note if you buy a echotech vectora m1 it dose not take soft tube plumbing you will have to hard plumb it.

With the bubble magus curve 7 it doesn't leave much room for a in sump reactor so I have to make a spray bar for the two out of sump reactors I want..


Sent from my iPhone using Tapatalk

mcgyvr
06/20/2017, 10:41 AM
I believe the term you are looking for is "return manifold" not spray bar.. A spray bar is a type of manifold in essence but a manifold is not really a spray bar.. A spray bar is located at the output of the return pipe in an effort to spread flow out over multiple ports vs a single return output tube..

A manifold has "T" connections and valves to allow you to T off some of the return pump flow to feed reactors or other areas besides just returning the water right to the display..

Very nice looking tank/setup though.. I'm sure you will enjoy it..
Looks great..