PDA

View Full Version : Osmolator Flashing


chrissreef
08/24/2017, 01:58 AM
Headed to MACNA and set this up tonight for the wife and the too high/too low flashed red at me. I unplugged/replugged it back in and it didn't flash at me.

Any idea what this might mean? I'm worried and catching a plane in a few hrs. Thx!

2una
08/24/2017, 02:12 PM
If the pump/solenoid stays in the on position for more than 10mins it does that as a safety

rvitko
08/24/2017, 04:50 PM
Sorry, I spent yesterday driving to NO for MACNA. Too high and too low usually means water damage, too low only means it timed out, pump was on 10 minutes, all 4 lights means the pump is bad (blinking). This is not to be confused with a normal start up which is all 4 lights flash, one light shows for status, then the pump runs 15 seconds and normal operation ensues. If these codes show after normal operation has started that is where we need to be concerned, water damage is almost always because a wet power supply tip was plugged in.