PDA

View Full Version : I'm a programing illiterate!


beertech
09/18/2017, 05:04 PM
I need help setting a profile for my single Stream 3 pump.
I would like to duplicate the fast pulse wave action I am getting from the tunze controller.
I would like to run it at 99% during the day, and drop it to 50% at night.
I've tried using the pre set "Wav" pulse profile, but can't get it to work with the tunze. I'm guessing I have to write my own and then set the variable outlet to run the two profiles.
I'm using Varspd3_L3 as the outlet. I've already got the cable hooked up properly and have the feed timers set and light profiles set on other outlets, but I can't figure out this pump.
Any help would be greatly appreciated!

slief
09/19/2017, 11:12 AM
Take a look at this thread. The profiles I have listed in there should do what you want. You will need to enable "Divide By 10" in the profile for a fast pulse. In var speed 3, you will need to call out the profile. Again, if you read through the thread below, it should explain in great detail what you need to do. i would suggest reading the entire thread as any questions you are likely to have will be answered within that thread.

http://www.reefcentral.com/forums/showthread.php?t=1994312

beertech
09/19/2017, 07:48 PM
Got it!
Made a few adjustments to match my situation and it's working perfectly!
Thank you very much!

slief
09/19/2017, 08:02 PM
Got it!
Made a few adjustments to match my situation and it's working perfectly!
Thank you very much!

Glad to help!

beertech
09/21/2017, 04:54 PM
Oh, I just noticed your job description...
I have a Bubble King 160 on my heavily stocked 120, and I just want to say it's phenomenal!!

slief
09/22/2017, 11:23 AM
Oh, I just noticed your job description...
I have a Bubble King 160 on my heavily stocked 120, and I just want to say it's phenomenal!!

:beer:

They are great skimmers!