PDA

View Full Version : skimz skimmer DC alternate Replacement pump?


fe342185
11/01/2017, 09:16 PM
My pump has died for my sm203. I literally have to jump start it to get it going. I want to replace it with an alternative. Any recommendations?
OEM is a vsc5000-DC pump

scuzy
11/01/2017, 09:48 PM
A jebao dcs5000 [emoji4] it's internally same pump


Sent from my iPhone using Tapatalk Pro

fe342185
11/01/2017, 09:56 PM
Thanks. I see them on amazon as return pump. Can the needle wheel just be swapped?


Sent from my iPhone using Tapatalk

scuzy
11/01/2017, 09:58 PM
Yup


Sent from my iPhone using Tapatalk Pro

fe342185
11/02/2017, 08:52 AM
Thank you very much

fe342185
11/04/2017, 08:23 AM
Dcs5000 is NOT the same. I ordered and the case is a completely different and cannot be retrofited. The input and outputs is much larger. I ordered the dcp5000 which is the 2017 model and I was able to modify to make it work. I needed to dremel holes on the base of the mount. Also the old volute must be used and with a minor mod i was able to use it. Lastly the needlewheel must be used with the new propeller shaft.

The new pump is cheaper and less than half what BRS is asking for a direct replacement.

PPi
07/10/2018, 05:29 PM
I just ran into your same problem. Wondering how it worked out for you since you installed / modified. Curious as to the mod you had to do to the volute. Pretty ticked off that skimz only discontinued the sv223 / vsc5000. Skimz customer service is lacking. Asked for a simple question on if there was a replacement or their new qps pumps were compatible and they wanted me to give them all of my paypal info, id, shipping info, and blood type, then they would give a price. Not sure where the simple question of yes or no went. Lol

Thanks and happy reefing!

fe342185
07/10/2018, 06:03 PM
Everything is working great and it’s even quieter than before. I bought an extra pump as a spare since it worked out so well. Figured I could use it as an emergency return pump if the vectors fails.

PPi
07/17/2018, 06:18 PM
What did you have to mod on this pump besides the locking tabs? Did you just use the impeller on the new shaft?

fe342185
07/17/2018, 08:02 PM
To be honest I do not remember. I believe I did have to move the needle wheel.