How do I prevent Streams from shifting position?

[djfrankie]

Hi Roger,
Finally got the magnets!! Great product!

I'm having this problem with the actual pump shifting position on its horizontal axis after a while. My streams are about a year old and the teeth on the clip mounts have kind of worned out a bit, enough to make them shift angle over a few hours.

I have been using tie wraps to keep them in position, but would like to know if there's an alternative?

thanks for your time,
djfrankie

[rvitko]

It is pretty much just an issue of meshing them down well, The only alternative would be to tap a thread through the pieces and screw them together with a nylon screw, 8mm is the correct size, probably a standard size would fit too.

[djfrankie]

Thanks Roger,
djfrankie