7094 operation question

[wrassie86]

Hi i am trying to get a slower switch rate out of the 7094 controller and cant figure it out.
In my tank 125g 6 foot tank i have 2 6100's one on each side pointing at each other and they switch in pulse mode every 5 secs or so.but i would like atleast a minute or alittle longer intill the switch.how do i set the controller?
i thought i could do this through low and high tide setting.but dosent seem to work.

[wrassie86]

Little more info..heres how i have it set up
plugs in sockets 9 and 11 set to tide mode -><- interval switch @ 1-7 minutes i have the knob turned to min (i assume 1 minute)
the lights ubove sockets 8-10 stay lit and never switch to 9-11 the second pump never comes on.

I have always used the controller in pulse mode and never had a problem intill trying this other mode i assume is not working.please lmk what you think.

[rvitko]

Use sockets 8 and 11, first and last.

[wrassie86]

Thats what i meant 8-11 i have been messing around with it for awile now and it just dont want to switch.I did clean the contacts and switched cords with no change.

[rvitko]

I would try disconnecting the pumps from power and be sure the cables are firmly connected. The green interval LED should be on if both pumps are properly connected.

[wrassie86]

its working now!i took it apart and cleaned it with contact cleaner.and reversed the pumps in the outlets.now it working.i think i may have a bad cord.

[rvitko]

Could be, it doesn't take much corrosion in the socket or cord to cause a problem. You may have it but if it acts up again. Someone posted that they sell these cables at radio shack and the best part was they were color coded.

[wrassie86]

Thanks, i'll have to pick up some of those cables.