Drilling for the first time?

[NYBen]

Hey i'm going to be drilling a 33 or 45 for a prop tank and was wondering if someone could sequence the steps for the dremel method, or provide a link if a thread already exists. I am aware a diamond hole saw is probably the way to go, but I have the dremel, and no hole saw, plus I like the challenge. Thanks...

Also is there a DIY bulkhead thread or any ideas on that....?

[NYBen]

Anyone? ^^^

[dwdenny]

http://www.reefcentral.com/forums/showthread.php?s=&threadid=603816 This will help out and you can get cheap hole saws here http://www.richontools.com/index.html or here http://stores.ebay.com/Treasure-HK-Ltd Dremel tend to make ugaly holes but if you dont care them have at it. HTH

[coralguy1]

Wise man say "jagged hole in glass tank lead to wet floor"
Get a hole saw and do it right.

[dtaranath]

hole saw is definitely the way to go. but if you really want to use the dremel method, check out this thread:

http://www.reefcentral.com/forums/s...threadid=751988

[timschmidt]

Make sure your hole is at least two inches from and edge to prevent cracking, mark your hole with pen (on the opposite side you will be drilling), then use blue painters tape to cover pen. Place set up with water running over drilling area (outside with a hose pointed to the hole) and drill at a slower speed (wear goggles) and take your time. Since a dremel is not perfect take your time and check with the bulk head you plan on using. That way you can see if your hole is not round. You will have to slowly shape the hole to fit the bulkhead. Good luck and HTH.

[jmkarcz]

You know, I did like 4 holes with my dremel. Having done 20 holes with a diamond holesaw and some water, and a Black and Decked cordless, I laugh thinking I used to be like you. (no offense)

Your way, 2 hours at lease, or listening to the high pitch grinding... breathing silicates and worse yet, maybe breaking your tank.

The right way... 45$ and a drill. and if your slow, 10 minutes form start to finish. 12 if you count cleanup. Apply very little pressure... maybe only the weight of the drill, and i prefer to wobble the drill slowly. don't over rpm the cut 300-500 rpm.

I've been there, do it right, save the time, and buy an extra round.

Jason