Final run thru for CLM, please inspect

[ezhoops]

My CLM ran by a Dart is about to be assembled and I need your final review in case I missed anything.

please tell me if this will work

http://img.photobucket.com/albums/v654/ezhoops/100_1184.jpg

[ezhoops]

I know that I shouldn't use the 90 right at the beginning but I only have so much room, maybe I'll use 2 (45's) instead, followed by the ball valve and then the true union to my Dart and then upwards to another true union and then to the CLM. 6 outlets

the pipe is 1 1/2" all the way thru to the outlets which are 3/4" loc-line.

http://img.photobucket.com/albums/v654/ezhoops/100_1183.jpg

[melev]

It looks rather bulky, but should work. Be sure you have a large intake screen to avoid hurting livestock due to the suction of that pump. There is a large one on aquaticeco.com Just look up strainers.

[ezhoops]

Bulky....how could I trim it down? I thought the goal was to prevent as little friction as possible, thats what my goal was, hence the larger ball valve and the 45's used in the CLM.

[kneival]

Not sure but dont you need a valve on the outlet side for pump cleaning? Or a way to drain the pump down and stop the syphon from the outlet end?

[melev]

It just looks big, but the pump is massive too. I don't really see a way to work around that.

[Shadowknife]

Hmm, that's pretty much identical to what I was planning for my 75, let me know how it works out. Is in intake piping all 2"?

[ezhoops]

no actually all the pipes are 1 1/2", I plan on gluing it up tonight oh wait super bowl, ok tomorrow