Clamping a flange

[nikolay]

I did some research and asked Zephrant about the easiest and safest way to make a flange for a Ca reactor - to use a router and a circle cutting jig.

What I can't figure out is how to clamp the material down so I don't have to stop the routing, move the clamps, and then finish the work.

Is there any trick for clamping down the material so the cutting is done in one go?

--Nikolay

[Donw]

If your using a circle jig that moves the router (not a router table) you can use double sided capet tape to hold the work piece to a scrap piece of plywood.

Don