PDA

View Full Version : Need some help


swamp63
03/01/2006, 07:57 PM
I need to cut some baffle for my sump can anyone tell
me the best way to cut .250 in. acrylic. TIA


Kelly :)

dugg
03/01/2006, 08:11 PM
Use a table saw.

swamp63
03/01/2006, 08:47 PM
Thanks Dugg ido have a table saw what would be the best type blade to use.


Kelly

eddybabyhd
03/01/2006, 08:50 PM
plywood/plastic blade...i got mine from home depot...anything 110 teeth or higher is good, thats based on 7 1/4 inch

exoticaquatics
03/01/2006, 09:31 PM
You'll need a flush trim bit for your router to clean up the edges probably. Unless you spend some money and get a nice blade that is made for acrylic. But the good ones run over $100. So its cheaper to get a cheap blade and clean up with a router.