PDA

View Full Version : MH retro fit with tank brace?

msuzuki126
03/15/2006, 06:09 PM
I plan on getting a 175 MH retro fit kit and mounting it in a canopy for my 37 gallon bow tank. The problem is that I have a brace in the middle of the tank. Should i remove the brace because it would affect the Mh lighting? Any ideas? thanks alot
msuzuki126
03/15/2006, 06:15 PM
any help please?
jasonj90
03/15/2006, 07:28 PM
do not remove the brace, or else the glass will bow once filled with water. most people like myself just deal with the small shadow. if the lighting is high enough off the water, the shadow will not be too noticeable. i assume that you are doing 1x175w... if your doing 2 then just place one over each side...
msuzuki126
03/15/2006, 08:05 PM
yes im going with one thanks alot
msuzuki126
03/15/2006, 08:21 PM
should i worry about possible unequal light distribution?
jasonj90
03/15/2006, 08:45 PM
i would run the light with the reflector opened to where the end of the bulb is pointing to the front of the tank. this way the reflector will distribute the light as far possible across the tank. luckily for you, in a smaller tank, the light will be just fine. adding some vho, or pc lighting as supplemental light, will also help to reduce your shadow prob. or you can put the mh on one side and just put your light needing corals and such under that one side. good luck...
msuzuki126
03/15/2006, 08:50 PM
k thanks alot!
supertech3
03/15/2006, 09:14 PM
IMO you will not even notice the brace with the lights on, it is not that big to block the lighting