PDA

View Full Version : bulkheads and rubbermaid stock tanks


szwab
04/14/2006, 12:12 AM
has anyone placed a bulkhead on the curved part of a stock tank?
I'm looking to add a 1.5 inch bulkhead and ideally it would go on the curved part but I am concerned with how well it would seal there. anyone who has done this your input would be appreciated.

thanks

jacob30
04/14/2006, 06:38 AM
Getting ready to install one myself. I am planning on putting it on the flat surface right in the middle which is slightly angled down.

cvye
04/14/2006, 07:26 AM
I have a light-duty bulkhead there on the curve, and it leaked a tiny bit. I applied silicone sealant inside and out, and it's fine now.

szwab
04/15/2006, 01:05 AM
thanks, what size was it?

geo
04/15/2006, 06:41 AM
uniseals would do the trick. www.savko.com carries them

turbonegro
04/15/2006, 08:34 AM
I put a 1.5" heavy duty schedule 80 on the curve part of the sump. It leaked when I ran a water test for the first time. When you install the bulkhead to the sump apply aquarium silicone around the bulkhead. Put a good amount both inside and outside the bulkhead. I did this and it worked for me.

szwab
04/15/2006, 12:22 PM
<a href=showthread.php?s=&postid=7181269#post7181269 target=_blank>Originally posted</a> by geo
uniseals would do the trick. www.savko.com carries them

and i was just there getting a gate valve..... guess I'll just ahave to stop in and se them again on Monday. thanks for the tip didn't even think of a uniseal.