PDA

View Full Version : DOC skimmer 9210

hammondegge
05/06/2006, 03:58 PM
i am looking to replace the pump for this skimmer. it appears to be turbelle model 230.04a. any ideas? i dont see them on the tunze site.
robert
rvitko
05/06/2006, 04:07 PM
Why do you need a new pump? They should last for years? They are available, they are very expensive though. A whole pump is about $160, just the motor coil is about $90. It should be warranty unless the cord was cut or it was abused in some way.
hammondegge
05/06/2006, 04:11 PM
well roger, the impeller has stopped turning. i managed to get it to work intermittantly for a week or so, but now it will not turn at all. is it servicable?
hammondegge
05/06/2006, 04:13 PM
my bad, the skimmer is actually model 230/3
rvitko
05/06/2006, 05:22 PM
That would say to me you need a new drive unit. I would stop running it since you could permananetly ruin it. You should check the sticky at the top of this forum on cleaning the pumps. It is written for Streams but the basics are the same. I suspect the upper bearing is dragging. If you wanted to just replace the drive assembly you need part 3000.60. We will be closed for 2 weeks. Marine Depot may have these in stock, I can probably also arrange to have my employee ship one to you if you need.
hammondegge
05/07/2006, 09:28 AM
i took it apart and cleaned it, and sure enough something about the drive unit is causing it to stick. i will order a new one from MarineDepot today. thanks for your help Roger
rvitko
05/07/2006, 11:15 AM
Check that upper bearing, this is often stuck to the magnet and the magnet should instead spin freely on it.
hammondegge
05/07/2006, 04:02 PM
Roger, i just noticed that you are in austin. so am i. the upper bearing was not stuck. it seemed like the brakes were sticking in both directions if that is possible. anyhow, i broke part of the plastic on the drive unit. so ..... gotta get a new one. i am in south austin near zilker park, where are you. please come join us on the new austin site www.austinreefclub.com
thanks again for all of your help. its Tunze for me from here on.
robert
rvitko
05/07/2006, 04:48 PM
I am leaving for Germany tomorrow. AquaTek should have that part in stock. I would suspect their is calcium build up in the brake shoes, it may just need cleaning.
hammondegge
06/17/2006, 12:37 PM
roger, i replaced the drive unit and it worked for about a month. now the drive unit seems to fit too tight to turn. should i replace the pump entirely?
rvitko
06/18/2006, 11:42 AM
Can you drop it off at AquaTek and I can test it?
hammondegge
06/19/2006, 08:40 AM
sure will