jnarowe
07/12/2006, 07:31 PM
So I have an issue that maybe someone with intimate knowledge of the ACIII Pro can help with:
I need to shut down my skimmer air pump when the collection bucket gets full. I had been using a "Weatherson" shut down system but with 100 liters/minute of air going into my 50g skimmer, the back pressure caused it to explode. (And no, I am not kidding. :lol:)
So rather than using a mechanical shut down process, I need to send a signal to the ACIII Pro to stop the air pump. I guess some kind of float switch system would work but I need advice on the components to use. For instance, if I wire a float switch to the digital input on the ACIII Pro, does it need to be powered, or will just completing a circuit signal the controller? Does it need some kind of relay then too?
Any advice on how to set this up would be greatly appreciated!
Thanks!
I need to shut down my skimmer air pump when the collection bucket gets full. I had been using a "Weatherson" shut down system but with 100 liters/minute of air going into my 50g skimmer, the back pressure caused it to explode. (And no, I am not kidding. :lol:)
So rather than using a mechanical shut down process, I need to send a signal to the ACIII Pro to stop the air pump. I guess some kind of float switch system would work but I need advice on the components to use. For instance, if I wire a float switch to the digital input on the ACIII Pro, does it need to be powered, or will just completing a circuit signal the controller? Does it need some kind of relay then too?
Any advice on how to set this up would be greatly appreciated!
Thanks!