heating and cooling programing questions?

[IRISSERVICE]

I'm looking to setup my heaters and chiller,but am haveing a hard time understanding terms...

This is what i have
2 x heaters
2 x fans
1 x chiller
This is what i would like todo

79 would be my ideal temp...

Have fan 1 turn on at 79.5
Have fan 2 turn on at 80.0
Have chiller turn on at 80.5
have heater 1 turn on at 78
have heater 2 turn on at 77.5

I'm guesing i want deltas to .5?
Thanks
John

[Captain Quirk]

I'm the LAST GUY on this planet that you would want to answer this, so I won't even try.

Can't SOMEONE answer this question?

Beuller?

[speedingredline]

I would like to know as well. I haven't tried in a while got to frustrated last time

[RonBuck]

Since some people are slow at answering there forums I will give the best advice I can.

If you want your Temp to be an average of 79 degrees do as follows:

Heaters: Program 1

Ref: 79 degrees
Min Delta: 0.5 Max Delta: 0.5 (I recommend a 1 degree swing so your plug doesn't switch on and off to often)
Plugs: Set plug state on lower row of power bar to have Icon above the letter your heater is pugged into, with the letter highlighted. For the Upper row, set heater letter to have icon above and not highlighted. (make sure you are on the correct power bar if you have more than one power bar)

(this means your plug will turn "on" when your temp reaches 78.5 and turn "off" when temp reaches 79.5)

Fans: Program 2

Ref: 79.5 degrees
Min Delta: 0.8 Max Delta: 0.1 (So that your fans to turn off until you have reached your choice temp)
Plugs: Same as above accept, use the plug that your fans are plugged into and Highlight the upper row and not highlighted the lower row of letters the fans are on.

(Say your fans are on plug "D" on PU02, use the right arrow key on the interface main screen to scroll to PU02 then scroll right to plug "D". Set Icon on upper row, by pressing the up arrow, and highlight "D". On the lower row By pressing the down arrow, set icon above and keep highlighted.)

Fan 2: Program 3
Do as above just set the ref point to 80 degrees. I personally would leave this fan running until your temp is at your preferred temp.

Chiller: Program 4
Ref: 80.5 degrees
Min Delta: 1.5 Max Delta: 0.1
Plugs: Set them the same as you did for your fans. To come on at Max Delta and turn off at Min delta.