Steve 926
11/29/2006, 09:58 PM
Hello,
I could use some info. on drilling the back of my 38 gal. I have a general drill guide for a hand held drill & a 45mm diamond hole saw. I intend to use mineral oil, or water as a lube while cutting the glass.
any idea as to speed of the drill, should I tape, & back up the inside with plywood to give it some support.
I was thinking about 3 1/2 to 4''down from the top edge of the tank for the hole. Never drilled any glass, but I think I can do it with some help
I would welcome any advice:smokin:
I could use some info. on drilling the back of my 38 gal. I have a general drill guide for a hand held drill & a 45mm diamond hole saw. I intend to use mineral oil, or water as a lube while cutting the glass.
any idea as to speed of the drill, should I tape, & back up the inside with plywood to give it some support.
I was thinking about 3 1/2 to 4''down from the top edge of the tank for the hole. Never drilled any glass, but I think I can do it with some help
I would welcome any advice:smokin: