lost PH

[MARKC123]

And yet another problem, after perfoming the update and controller shutting down I lost all my programing. Three hours later and all programming complete my system is not showing my two PH probes. But it is showing two extra temp sensors with readings of 181 deg and 131 deg. I unplug the PH probes and the two temps start to flash I plug them in and back too the crazy readings... what happened to my PH sensors??
mark

[ik2vov]

Hi MARKC123,

you have to disconnect manually every pH module and every temperature sensor thru the menu. Unplug the temperature sensor, the controller will tell you to confirm you removed the sensor then press ok. Then enter the main menu for the temperature sensor you will see every sensor he recognized if you press the first you will see a "disconnect", press on it and press ok for the confirmation, do the same for all the duplicate sensor and for the pH module.
When you have cleared the situation with no sensors and pH module connected, connect the temperature module and wait that it will be recognized, press ok when recognized and plug in the pH module with probe connected, wait it will recognize, press ok. Now you should have it ok.

Bye

[MARKC123]

i will do it..
thanks

[MARKC123]

I disconnected all the temp sensors and ph probes through the main menu.. I reconnected both temp sensors, but whenever I reconnect the ph probes both of them are showing up as TEMP SENSORS instead of PH

[MARKC123]

i tried again this time hooking up the ph probes first... all is fine
thanks for the help

[ik2vov]

I'm happy you solved.

Bye