[b]Spray Protection[/b]

As far as spray and salt creep is concerned, you want to avoid buildup on the lamp itself. No matter what you do, there will still likely be some buildup due to evaporation, so you will want to wipe off the lamp or fixture periodically (as needed). Make sure the lamp has cooled down, remove the lamp if possible, and wipe it down with a soft cloth and warm water. This is rather easy to do in place with T5HO lamps, and more difficult for spiral and multi-tube...

[b]Fasteners[/b]

Most people have uses standard zip-ties to secure the screen to the slot pipe, since they are cheap and easy to use. Generally you have to use new ones each time you clean the screen (because you have to cut them), or you can re-use them if you’re handy with the tip of a razor blade and can get them to release.

You can also use releasable zip ties (I found them in the electrical section of Home Depot), but they’re not as easy to release as you would...

[b]Cutting the Slot[/b]

The width of the slot should be approximately 1/8" wide, the same length as the screen which you are using (as exact as possible), and as straight as possible. Cutting a straight, even width slot is arguably the most difficult and critical part of building an Algae Scrubber. If the slot is crooked or uneven, the screen may not hang properly, and there may be areas where the flow is lighter and heavier. This can result in sections of weak growth....