View Single Post
Old 08/08/2016, 06:25 PM   #10
neiltus
Registered Member
 
neiltus's Avatar
 
Join Date: Jul 2016
Posts: 467
Oldcabin-On the overflow, just put about 6" of water in your pump chamber...put a witness mark with tape (see above).

Turn on pump.

Crank down on the knob from open to close till the sucking stops. Wait a couple minutes and move it a few thousandths to fine tune. Note that the water level in the overflow will be an inch or two below the emergency tube.

It's only hard if your afraid of messing up. The emergency overflow will prevent from flooding tank and running pump dry.


__________________
Build Thread

http://www.reefcentral.com/forums/showthread.php?t=2592260
neiltus is offline   Reply With Quote