Well it has been a while since I posted and thought I would update this thing.
The plumbing was straight forward. I went with the bean animal setup with one difference. Bean in his set up had the second drain output larger then the rest. 1" to 1.5". I left them all at 1".
The bulkheads extended from the back side of the tank far more then I wanted. I decided to risk ruining them to cut them smaller to allow me to get the tank closer to the wall. I left the nut on the bulkhead so that after I cut them it wouldn't be hard to get it on. Which also mean I cut them while they were in place on the tank. I used a dremel and the cut went pretty easily. They melted mostly. But all in all I was happy with the results.
|