View Single Post
Unread 11/27/2017, 08:09 PM   #5
Registered Member
Join Date: Jun 2005
Location: Lincoln, NE
Posts: 318
Kudos on the printer work. Very nice.

I'd suggest moving to ABS for a few reasons, the biggest of which is that it can be solvent bonded and solvent smoothed (vapor polished) to make a solid surface. It would make embedding and sealing magnets quite easy. Plus no need to worry about poor bonding between silicone/plastic dip and material, as they wouldn't be needed. I'll post a kalk stirrer design I have been working on in the next few days that uses this kind of embedding for magnets if you are interested.

Current build thread :

I ate a jellyfish... tasted like soy sauce.

Current Tank Info: 180 gallon system in progress
jrhupp is offline   Reply With Quote