View Single Post
Unread 05/05/2012, 08:33 PM   #4
sceia
Registered Member
 
Join Date: Jul 2011
Location: Fulshear, TX
Posts: 75
Not sure if any of this will help you, but I just finished my led setup. I have a 210g (72x24x30h)... Below is the diagram I used. The heat sinks are 8.5x18" and are about 14" above the water. I used 10 inventronics drivers to drive all led's on 6 channels. I'm disappointed in the incentronics as I thought I could dim them more than they do. I would suggest meanwells instead. I get really good spectrum with them all around 85-90% ramped up. I did go thru a brown phase when I swapped out, but the color is quickly coming back. I had mh's before. I can say this...there's no comparison with the shimmur of the leds. Makes a huge difference...and the royal blues make everything pop! If you have any specific things I can help with, just ask...

Scott.






sceia is offline   Reply With Quote