Reef Central Online Community - View Single Post - Stockman Standpipe--New, Easier Design

BonsaiNut · 09/29/2003, 10:27 PM

And this is supposed to be easier than a standard Stockman?

Stockman = pipe and t-intersection and 90 degree bend and cap. Takes about 5 minutes to make and less than $5 in materials. I don't quite get this "improvement" - if only because it requires a lot of labor.

BTW - I am NOT knocking you; I like when people try to improve stuff. I just don't see how this is easier

Work on a Stockman Protein Skimmer

09/29/2003, 10:27 PM	#23
BonsaiNut Premium Member Join Date: Mar 2002 Location: Orange County, CA Posts: 4,629	And this is supposed to be easier than a standard Stockman? Stockman = pipe and t-intersection and 90 degree bend and cap. Takes about 5 minutes to make and less than $5 in materials. I don't quite get this "improvement" - if only because it requires a lot of labor. BTW - I am NOT knocking you; I like when people try to improve stuff. I just don't see how this is easier Work on a Stockman Protein Skimmer __________________ "You are a very fine person, Mr. Baggins, and I am very fond of you; but you are only quite a little fellow in a wide world after all!" - The Hobbit; J. R. R. Tolkien