View Single Post
Unread 10/24/2007, 11:47 PM   #3
Corndork2
Registered Member
 
Corndork2's Avatar
 
Join Date: Sep 2007
Location: Peoria, IL
Posts: 511
There are three wires coming from the power cord; white, green, and black.


Strip the black and white wires from the length of power cord with the plug attached to it. We won’t strip the green on right now as we won’t be using it until we mount our ballast in its casing later on.


Now take the black wire from the power cord and connect it to the red wire of the ballast with a cap.


Next take a look at the length of 16 gauge cable that did not have the power cord on it.


Cut the green wire off of the cable. It’s not needed.


Then strip the black and white wires.



Corndork2 is offline   Reply With Quote