Quote:
Originally Posted by ReefKeeper64
Hey Slief, Thanks for these links. This is most helpful. I checked and the pump heads support LS17 (1/4" inner diameter) tubing. They also support the slightly larger LS18 (5/16" inner diameter) tubing.
Should I consider the LS18 tubing since this is for water changes? I figure the fewer RPMs needed, the better. Perhaps 17 just works better for water changes with regards to vacuum or something along those lines?
|
If it supports LS18 tubing than why not. You will run the motor at lower RPM's or for less time which is always a good thing. You will just need to look on the US Plastics site for the correct barbed fittings. You could still pair it with the 1/4" RODI tubing though.
__________________
Director Customer Support Royal Exclusiv USA
For All Royal Exclusiv & Bubble King questions please refer to our Sponsor forum:
http://www.reefcentral.com/forums/fo...play.php?f=745
Current Tank Info: 480G display mixed reef, 90G sump, 90G refugium, 60G display refugium. Check out my build thread: http://www.reefcentral.com/forums/showthread.php?t=1783476