[slief]

Originally Posted by ReefKeeper64

Hello all,

Would anyone mind taking a picture of their lids removed from your dreambox and set on the floor or a table? A straight down shot will make for a good reference template.

Also, would you mind also posting a picture of your lids back in place on your dreambox? That will give me a good idea how much clearance I should have between the opening and the skimmer. Mine is a BK180.

Thanks!

I think you can make the skimmer cutout a bit tighter. It's ultimately up to you though. If it were me, I would position the skimmer so the pump was easy to access for routine maintenance and keep the cutout as tight as possible to minimize evaporation. Also, if you use a small pot lid and an exacto knife, that will help you get that cutout in the template nice and clean.


Here are a few picture from the European website.