I have two questions, which should be simple.
1. When I purchased parts, I purchased 1 gate valve and 2 ball valves. At this point, I don't know why I purchased the ball valves. I was convinced I needed them for the second/third drains. Did I imagine this?
2. Is there any "proper" placement for the gate valve in terms of "distance from overflow box?" I have a simple 36" stand, 40 breeder, going to a 20 gallon sump. Can I put the gate valve in the lower compartment, or should it be mounted on the vertical downpipe? I see it done both ways, but would prefer it below so it's not against the wall and easier to reach.
Thanks.
|