My plans comments please.
I wanted to build this all myself : stand, sump, frag tank and main tank.
I wanted the stand to house the tank and frag tank and tied to the same sump.
The frag tank is going to be 6 or 8 inches high and 20"x20: rimless maybe 24"x24" Is 1/2" overkill?
The sump in gong to be 33″ long x 15″ wide x 15″ high I was going to use the rest of the 1/2" from frag tank and make the inside panels 3/8 and hopefully rimless? overkill using 1/2"?
Now the tank I want 48"x30" x 20" I have used the calculators and one calculator say 1/2" says it is fine with framing and other says 3/8 is fine. I want to use either euro or just a brace down the middle. Problem is 3/4" is 487.00$ and would require 2 pieces. That is more than I wanted to spend. I do not feel 1/2" is enough and should be 3/4".. Anyway to do this and save a little money. Maybe use 1/2" bottom and framing and 3/4 for the sides? Still is allot of money. I could reduce size some?
Are there more charts or calculators for acrylic other than garfs and
http://diyfishkeepers.com ?
My choices locally for Plexiglas-G is 62x96: 1/4 214.00, 48x96: 3/8=240.00, 1/2" 322.00 and 3/4" 488.00 sound reasonable. 10.50 per 1/2 hr to cut.