Small update.
Tank was lifted off stand, the access hole was made much bigger, and tank was put back on. I did the plumbing from /inside/ the stand this time instead of putting the tank on with the plumbing on it just to be sure I could if down the road it happens again.
Took my sweet time and made sure the gasket was where it should be and immaculately clean. Tightened it a 1/4 turn after finger tight.
Filled the overflow and attached the plumbing, and it didn't leak overnight, so right now it looks good to go again.
While hoisting the tank back on, it drew blood when a thin wafer of glass chipped into my thumb. Posted a thread about that in the help forum, but I think it will be okay. It was very thin, on the corner.
Moving forwards!
|