Reef Central Online Community - View Single Post - Who wants a cheap, simple, Arduino-based LED controller?

jc286006 · 07/30/2012, 09:44 PM

what i see on typhon schematic
is
jp1-----------------------lcd pinout
pin1 = gnd which hooks to pin1 Vss
pin2 =5v------------------pin2 Vcc
pin3 =Vo------------------pin3 Vee
pin4 =Rs------------------ pin4 Rs
pin5 =gnd------------- R/W on lcd not used
pin6 =en----------------- pin6 E enable signal
pin7--------------------- not used on lcd
pin8----------------------not used on lcd
pin9----------------------not used on lcd
pin10---------------------not used on lcd
pin11 =lcd4---------------pin11 db4
pin12 =lcd5---------------pin12 db5
pin13 =lcd6---------------pin13 db6
pin14 =lcd7---------------pin14 db7
pin15 =bkl----------------pin15 ledK
pin16 =gnd---------------not available on lcd

is this the correct wiring for my lcd? i have an actual pcb

07/30/2012, 09:44 PM	#1101
jc286006 Registered Member Join Date: Oct 2006 Location: ramsey illinois Posts: 218	what i see on typhon schematic is jp1-----------------------lcd pinout pin1 = gnd which hooks to pin1 Vss pin2 =5v------------------pin2 Vcc pin3 =Vo------------------pin3 Vee pin4 =Rs------------------ pin4 Rs pin5 =gnd------------- R/W on lcd not used pin6 =en----------------- pin6 E enable signal pin7--------------------- not used on lcd pin8----------------------not used on lcd pin9----------------------not used on lcd pin10---------------------not used on lcd pin11 =lcd4---------------pin11 db4 pin12 =lcd5---------------pin12 db5 pin13 =lcd6---------------pin13 db6 pin14 =lcd7---------------pin14 db7 pin15 =bkl----------------pin15 ledK pin16 =gnd---------------not available on lcd is this the correct wiring for my lcd? i have an actual pcb Last edited by jc286006; 07/30/2012 at 09:57 PM.