View Single Post
Unread 12/07/2005, 09:56 PM   #108
causeofhim
Registered Member
 
causeofhim's Avatar
 
Join Date: Dec 2004
Location: Janesville, WI
Posts: 1,379
When I placed duct tape on the inside of the tank where I was drilling the hole, the glass piece I was cutting out stayed in place until I was completely finished with the cut. On my first hole, the glass piece wasn't completely finished being cut and because of its weight, it broke away from the cutting and made a small chip in the edge of the hole.

Does that make sense?


causeofhim is offline   Reply With Quote