View Single Post
Old 12/07/2005, 08:54 PM   #106
causeofhim
Registered Member
 
causeofhim's Avatar
 
Join Date: Dec 2004
Location: Janesville, WI
Posts: 1,387
I just received my 60 mm hole saw from Lau. I used it to cut 2 holes in my new tank. Although it worked, I got some small chips on the holes. They are not too bad and I dont think will cause a problem. IT IS VERY IMPORTANT TO USE DUCT TAPE ON THE INSIDE OF THE TANK. I did this with my second hole and it was much better.
The shaft was not strait so the bit and drill wobbled when I used them. I e-mailed Lau about this and I'll let you know what he says in response.


causeofhim is offline   Reply With Quote