[Member No. 1]

To do this you will need 2 profiles.
This can be done in Fusion
Profile 1
This will ramp the moon lights down from a start percentage to a finish percentage over a fixed time.
1. Go to the profile tab, (looks like a file folder) then select an unused profile.
2. In the Name box, call it Lunar_Down
3. In the Type box, select Ramp
4. Set Ramp Time to 30
5. Set Start Intensity to 100
6. Set End Intensity to 10
Then click the save button.

Profile 2
This will maintain the moon light intensity at your predetermined setting.
1. Same as above if your'e not already in the profile page.
2. Name this one Lunar
3. Select Ramp
4. Set Ramp Time to 1
5. Set Start Intensity to 1
6. Set End Intensity to 1
Then click save.

You can adjust all these settings later to your personal liking.

Now go to your Lunar Outlet and click on Advance type.
Under configuration copy and paste this code.

Fallback OFF
Set OFF
If Time 21:59 to 22:29 Then Lunar_Down
If Time 22:29 to 01:00 Then Lunar

My Atinics go off at 22:00 (10:00pm) so I wanted my moon lights on before they went off.
So what the above coding does is it turns my moon lights on 2 minutes before my antinics go off and at 100% intensity. Then it ramps the moon lights down to 1% over the course of 30 minutes. Then they stay at that intensity until 1:00 am
then shut off.

Hope that helps.