Quote:
Originally Posted by slief
I think you have an address conflict. Disconnect the ALD from the Aquabus. Go into your module settings page from the classic dashboard and delete all ALD’s. This may solve your EB8 issue too. Then plug your ALD back in to the Aquabus. It should add your ALD without all the duplicates. Note that since the address is likely to change, programming associated with our ALD from your backup may need to be reprogrammed. If not, update the EB8 firmware as I mentioned above if you haven’t already done so.
|
So I have both EB8s back and running. The 3rd module in next order is the PM2 module. I connected it but its not showing up under modules no address listed for it and its flashing orange. Any recommendations on how to assign it? It was working earlier today with the last apex.