Quote:
Originally Posted by jason2459
Ok cool. Only issues I've had was all the readings just freezing in time until I unplugged and plugged back in the aquabus cable. Will see if it does it again after the firmware update. Not a huge issue just annoying.
Do you have the sensors horizontal or vertical and how much flow is going through? Any air being pulled in like microbubbles from a skimmer or from an overflow?
|
Actually the one in question is horizontal with the sensor body "hanging below", the other two are vertical. I suppose there is a chance to recieve micro bubbles from the overflow/input of my sump, although IF any it is very minimal, but the chance IS there. Flow through the horizontal 1" is 230-235gph. My 1/2" sensor is also horizontal and ran off the same pump/manifold, it's flow is 70-75gph. I'll keep an eye on the 1/2" as well...