I trimmed up the rest of the stand last night and resized the doors. Ripped them down and put hinges on and mounted. This was probably the most frustrating process I've been through on this tank so far. The hinges I bought were small (mistake #1) and while they hold up the doors fine they just leave little room for error. Mounting the hinges to the inside of the trim was mistake #2, that also leaves virtually no room to move the hinges side to side to adjust for the door swing, because the width of the trim is 3/4 inch. Lastly, I didn't leave enough room for the hinges when I resized the doors so I'll have to rip one of the two doors down again by like 1/8 inch or they won't quite squeeze in together. It's just a big PITA man. Lol.
I'm thinking of leaving the side 'doors' just as panels that I can Velcro in. Pop them in or out when I need to get into the sides if I ever do and call it a day. I'm just really hating hinges that much right now. Lol.