View Single Post
Old 08/17/2016, 11:15 AM   #2
Avast Marine
RC Sponsor
 
Avast Marine's Avatar
 
Join Date: Feb 2006
Location: Northern VA
Posts: 2,480
The hole in the elbow is a siphon break, what you are experiencing is surface tension. If you can remove the tubing from the output of the stirrer it will help. If you absolutely need the tube section then orienting it so the bend goes slightly upwards will help. Usually the surface tension break is about 1/2 fl oz so this is a very slow addition to the tank.


__________________
Dan

Don't rush art, you get bad art.
Avast Marine is offline   Reply With Quote