Quote:
Originally Posted by neilp2006
Uniseal through side at bottom, with 3/4 pvc pipe (couple inches) and a valve to a 90 pointing up. Put a cap in the 90 with a small uniseal that the probe will fit in (might need to work on this bit). Kinda like the small T fittings your rodi tds sensor fits in.
Edit- thinking about it some more, you’ll probably bust the probe trying to get it in and out of the uniseal. Should have thought it through some more before I made a suggestion.
Sent from my iPhone using Tapatalk
|
Actually you may be on to something putting it into a T. I could plumb the T in and out the strain relief fitting on the third hole. I'll digest that and see if I can fit it where I won't break something. Thank you for the suggestion.