Finished the fabrication of the stand for my new build this weekend, 84" long by 32" wide by 30" tall. Need to grind the welds and put some paint on it. The stand is 2" x 2" 11 gauge square tube. I just free wheeled the design based on what I saw in the steel stand thread but added a 45 degree gussets on the top outside corners. I could still add to it if needed so I am seeking opinions on the design.
Still trying to figure out where to get the tank from. Got quotes from four different places but it is all too much. Probably if there were less options it would be easy.