Quote:
Originally Posted by kruserm
...
We could but I was initially thinking of getting the controller running first as I would want the controller for the leds, but either way doesnt matter to me. What are your thoughts?
|
let's see if we are in the same page
[CONTROLLER: Hydra or Arduino]
> [ DRIVER: LM3409 board ]
> [ LEDs ]
by controller you meaning hydra or arduino 'layer', right? if you take the hydra route it'll be necessary to place an order in a PCB service the same as driver, you can buy they both together I guess.
i'm leaning toward to use the arduino board as a controller just because it is 'simple' and spend my energy on driver matters (i think it will be very hard).
a question just occurs right now: can I use just one controller to control all the drivers or it is mandatory using one controller to one driver?
thank you for helping me!
btw, all PCB services (seeedstudio, iteadstudio and batchpcb) only accept Gerber files not the .brd... so be prepared to install: