View Single Post
Unread 09/12/2007, 12:00 PM   #3
ThaNgBOm321
Registered Member
 
Join Date: Feb 2005
Location: Tx, houston
Posts: 792
if cutting with a table saw where the blade is under then good side up..... if you are using a regular circular saw.. then it's good side down... as stated above.. you want the saw teeth to 'bite/chip' into the good side...

YzGyz


__________________
YzGyz = Wise Guys ohhh and cows go MOOO!!!

2nd best way is to learn from ones own mistakes but the best way to learn is from others...

thx to Randy and so many other for making reefing that much easier
ThaNgBOm321 is offline   Reply With Quote