Quote:
Originally Posted by Chris918
Hello friends,
I recently ordered a tsunami lid from clearview. While I'm pleased with the general look of it, the custom cuts that were done for my light mounts are too small. Granted I should've asked for a cut bigger than the exact size of the mount so I take the blame there. The cut is the size I asked for, but because the acrylic curves on one end of each cut, the mount doesn't fit. Does anyone have any suggestions for how I could make the cut bigger? What's the best way to cut acrylic when I'm just making a small extension to a cutout area?
Thanks!
|
I don't know if it's the best way, but you can use a Dremel to cut acrylic.
Sent from my SM-N960U using Tapatalk