View Single Post
Unread 02/28/2007, 06:47 PM   #1
WaterbugJenn
Registered Member
 
WaterbugJenn's Avatar
 
Join Date: Jul 2006
Location: Mass,USA
Posts: 256
DIY Test tube holder

I made this because I was tired of balancing test tubes on my table and always knocking 1 over and spilling its contents. It was designed to hold 2 dif size tubes 1/2 in (aquarium pharmaceuticls) and 5/8 Red Sea tubes. The salifert tubes that I have are much larger and easy to balance. Only 15 min to make the board, took longer to stain and clearcoat.



__________________
lots of tanks over the years since I joined, lots o fun <-- delirium has set in there

ultimate gadget freak 72 bow in the works lots o diy <-- it's getting worse I must be out of my mind.

Current Tank Info: Shiny Dinero Vacuum
WaterbugJenn is offline   Reply With Quote