View Single Post
Unread 02/15/2018, 11:04 PM   #7
CTaylor
Registered Member
 
Join Date: Nov 2001
Posts: 1,524
Hi Roger
I followed the instructions on the video. My pumps are not stopped at lowest power setting from the multiconroller. The range goes fro 30% to 80%. But one pump will not turn more than just idle. The other pump goes through the range (it seems to). And the night mode was able to be activated again. This leads me to believe my multicontroller is just not fucntioning on many levels.
**Should I send it in to you to see if it can be repaired?
**if I had to get the 7096, what updates would I be missing out on? I didnt need any for the 7095 I have now. How is the mac version less sophisticated? Less functionality?
Right now I'm using the basic controllers that came with each Tunze 3.
**For now can I use https://www.bulkreefsupply.com/y-ada...300-tunze.html << Y cable. << Will this allow alternating wave action? for 2 Tunze 3. The descrption on that site says if you have THREE Tunze pumps, will it work for only two pumps?

Thanks again!


CTaylor is offline   Reply With Quote