New 700mA Dimmable Driver

[ReefLEDLights]

As reefkeepers we are very particular on the equipment we use on our reefs.

This driver is the first of many that are an improvement on the current drivers.

Our Hyperon does not need to be adjusted and can be directly attached to a potientiometer without a seperate power source.

Capable of driving up to 15 Cree XT-E LEDs

As the best of the best this is now included in our Phoenix DIY Kits



High Efficiency (Up to 88%)

Active Power Factor Correction (Typical 0.92)
Constant Output Current
Lightning Protection
Waterproof (IP66)

Dimming Control
0-10v input, signal scales the output linearly with input voltage.
Use the 10v Output (yellow) with a potentiometer for manual dimming control.
Dimming down to 13%

All-Round Protection: OVP, SCP,OLP
Comply With UL8750 & EN61347 Safety Regulations
Comply With ANSI/IEEE C62.41, Class A Operation
Comply With FCC Part15 Class B

[akaimal]

How many LED's can a Hyperon driver drive, in terms of LED types (XTE, XRE, XPG, XPE)?

Can it drive a combination of different types of LED's?

[ReefLEDLights]

Originally Posted by akaimal

How many LED's can a Hyperon driver drive, in terms of LED types (XTE, XRE, XPG, XPE)?

Can it drive a combination of different types of LED's?

Each LED has a different draw so that will change what driver you choose. To start you off, check out this page we made that explains it.

http://reefledlights.com/how-to-diy-led/driver-faqs/