MP40 Wet Side Solid non-Vented Area Placement

AZRippster · 07/09/2012, 10:45 PM

I own two the of MP40 Wireless pumps and have a question about the placement of the wet side assembly. There is a solid area, not vented, on the assembly. I was wondering if it matters where that solid area should go, as in top, bottom, left, right or it simply doesn't matter. I can't seem to find it addressed in the manual. Any advice or input in to this question would ease my mind.

Thanks!

EcoTech Service · 07/10/2012, 10:06 AM

It's designed to minimize sand/water from being pulled into the wetside, dependent on placement.

For example; if your wetside is close enough to the water surface that it might draw air (creating a vortex), simply turn the closed portion towards the surface.

AZRippster · 07/10/2012, 10:31 AM

Got it, makes sense.

Thanks!

07/09/2012, 10:45 PM	#1
AZRippster Registered Member Join Date: May 2012 Location: Sierra Vista, AZ Posts: 48	MP40 Wet Side Solid non-Vented Area Placement I own two the of MP40 Wireless pumps and have a question about the placement of the wet side assembly. There is a solid area, not vented, on the assembly. I was wondering if it matters where that solid area should go, as in top, bottom, left, right or it simply doesn't matter. I can't seem to find it addressed in the manual. Any advice or input in to this question would ease my mind. Thanks!

07/10/2012, 10:06 AM	#2
EcoTech Service Registered Member Join Date: Apr 2008 Location: Lehigh Valley, PA Posts: 1,431	It's designed to minimize sand/water from being pulled into the wetside, dependent on placement. For example; if your wetside is close enough to the water surface that it might draw air (creating a vortex), simply turn the closed portion towards the surface. __________________ EcoTech Marine Customer Service For FAQs, troubleshooting advice and direct interaction with the EcoTech staff, visit http://community.ecotechmarine.com or contact us by e-mailing support@ecotechma

07/10/2012, 10:31 AM	#3
AZRippster Registered Member Join Date: May 2012 Location: Sierra Vista, AZ Posts: 48	MP40 Wet Side Solid non-Vented Area Placement Got it, makes sense. Thanks!