|
02/06/2015, 09:19 AM | #26 | |
Registered Member
Join Date: Apr 2006
Location: Aurora, CO
Posts: 1,255
|
Quote:
http://www.marinedepot.com/miscellan...warmer-ap.html I addressed heat ranges on the first page, post #4, item H |
|
02/06/2015, 10:26 AM | #27 |
Registered Member
Join Date: Jun 2002
Location: NJ
Posts: 418
|
Sorry I missed that part about the temps. The reason I was asking is someone asked me to ship some sps, zoas and a chalice but his low temps were around 1-20 at night. I was hoping for closer to 30 for the low. So you think above 10-15 degrees is somewhat safe?
|
02/06/2015, 10:43 AM | #28 |
Registered Member
Join Date: Apr 2006
Location: Aurora, CO
Posts: 1,255
|
I'd personally wait, that's just my opinion. Zoas aren't the issue, it's the SPS.
|
02/06/2015, 11:04 AM | #29 |
Registered Member
Join Date: Jun 2002
Location: NJ
Posts: 418
|
|
02/09/2015, 11:32 PM | #30 |
Registered Member
Join Date: Feb 2009
Posts: 1,180
|
I have to ship a frag from Iowa to Florida. My concern is that when the package gets to Florida it will overheat from the heat pack. Is this a valid concern?
__________________
150g sps display with basement sump. |
02/09/2015, 11:37 PM | #31 |
Registered Member
Join Date: Apr 2006
Location: Aurora, CO
Posts: 1,255
|
Reality is the heat pack consumes all the air in the box, and the small hole is enough to keep the heat pack barely warm. I don't have a crystal ball, but I'd think there would be a problem.
|
02/13/2015, 12:44 PM | #32 |
Registered Member
Join Date: Apr 2006
Location: Aurora, CO
Posts: 1,255
|
So last month I shipped a package out and had a problem, where I had to go pick up the box I had sent, unpack it, after the box had sat at the FedEx facility all night. The following week these corals were repackaged, and reshipped with no problem. Also, for the first time, I had to ship a coral package in state, and learned a lot from that too. Here are my notes.
It was an experience (hope one not to have to do again) on unpacking one of my own shipments. First though, the story: My FedEx Priority Express drop off time is 6:00 pm. I target to get the package there between 5-5:30 which allows me time if any issues should arise during packaging. In this case, I was there and tendered the coral package at 5:15, no problem, right? Wrong. There were signs that I now know - should have been red flags, but those signs didn't cross me as odd at the time. BOTTOM LINE: Ask the clerk: Priority Express shipments didn't leave for the airport yet for the day - Right? This ensures the express truck did not get there early that day, as that was the root cause of this whole issue. In a nut shell, the express truck had passed by an hour early, and the employee tendering my package apparently didn't know. Further, as I explained on the first page of notes, you print your own shipping label so the clerk shouldn't be printing and sticking anything onto your box. If they are, RED FLAG, ask what they are doing. In my case, it was a new label, with a new priority tag. This was a Thursday, a package delivery for Friday by 1200pm (not 1030 which is something else I need to explore why). Anyhow, the new label said Monday... Which I doubt any of the corals would have arrived alive. Again, I didn't think a new label was odd and got my receipt, and left. Went home and added the buyers and my email address to the routing tracking number via the FedEx site. Still at this point, nothing seemed odd or wrong; not until the next morning. I normally have a few emails showing the movement of the package, for me in Denver, it usually always goes through Tennessee. Point being I knew something was off as there were no updates. I left for work (damn job getting in the way of my hobby again) and while at work, I looked online to see the package seemed to be at the first point drop off location. I called FedEx, and they said I missed the drop off time. I knew that was wrong and after explaining, they agreed and called the facility while I was on hold. They came back and told me the truck came early because there was forecasted inclamental weather in Denver. It was cold, but we didn't have snow but again, no one told me and I didn't ask. They ensured my package was held and I left to go pickup and unpackage the box. By the time I got there, and got home it was 10am. That's the average time my packages arrive to their destination so I decided to test the water temp of the corals I was unpacking The corals inside were between 75.4 and 76.6 which is completely fine. Still though, the box didn't leave the closed facility, and it was cold out that night, 20's. Putting another heat pack in the small box I feel is more a risk, but I don't know how much lower the temp would have gone inside the frag water. There isn't an exact science but I've thought if shipping where the temp are between 20-35 deg, of putting a gel pack at the bottom of the box (heated to 80 deg so the heat can slowing resonate). I've never asked anyone to measure the temp but to be honest, I know from getting packages there are enough things for me to worry about and do, measuring temp water isn't one of them. Shipping in state, I've heard and seen on FedEx site that one day delivery is possible for a large range extending from my city to most of my state, and even into some portions of surrounding states. Shipping ground is a heck of a lot cheaper than priority overnight. However, the fine print is this. Nothing is guaranteed and it can take up to 3 days. UPS was a lot cheaper than FedEx when shipping closer, so through my Shipnex account, I decided to try UPS. All and all it was the same, package and contents got there without a hitch. What I learned was ground is risky, so I don't have the warm fuzzy to trust it. Still, it was only $22 to ship where I normally see between $40-60. |
03/06/2015, 01:41 PM | #33 | |
code monkey
Join Date: Dec 2004
Location: south bay
Posts: 6,223
|
Quote:
__________________
I don't always grow frags... but when I do, I prefer Dos Acros |
|
03/15/2015, 01:51 PM | #34 |
code monkey
Join Date: Dec 2004
Location: south bay
Posts: 6,223
|
I wanted to add, I recently had to ship out two big boxes of corals for trades and it was a PITA with the specimen cups. They're amazing for smaller orders, but if you're packing 20+ corals into a box it's gonna get pretty big... Let's just say I'm back to owning a bag sealer. I prefer the cups for normal shipments since imo the corals get less stressed from floating instead of being squished into the side of a bag, but for 10+ frags a bag sealer is better. Happy to own both now, good options
__________________
I don't always grow frags... but when I do, I prefer Dos Acros |
03/15/2015, 02:07 PM | #35 | |
Registered Member
Join Date: May 2013
Location: Houston, Texas
Posts: 672
|
Quote:
__________________
- Matt Current Tank Info: 75g SPS ReefSavvy in the Works (prior: 260g SPS heavy system, 70g prop system, 29g Biocube) |
|
02/06/2017, 08:06 PM | #36 |
Registered Member
Join Date: Mar 2011
Posts: 114
|
Any updates on this?
I've been looking at fedex quotes and they range from $90-$120 for a 6x6x6 5lb box 10:30am overnight delivery. Is this accurate? It so how are people shipping for $45-$60? |
06/08/2018, 12:19 AM | #37 | |
Registered Member
Join Date: Oct 2010
Posts: 50
|
Quote:
Sent from my SM-N950U using Tapatalk |
|
07/12/2018, 08:35 AM | #38 | |
Registered Member
Join Date: Mar 2011
Posts: 114
|
Quote:
Thanks I'll look into them |
|
07/17/2018, 09:46 AM | #39 |
Registered Member
Join Date: Sep 2004
Location: Boston MA
Posts: 414
|
|
01/08/2019, 10:52 AM | #40 |
Registered Member
Join Date: Apr 2006
Location: Aurora, CO
Posts: 1,255
|
All, I got out of the hobby in 4/2015 for a lot of reasons. One of which is the hobby turned more into a business as I had large colonies, and couldn't frag fast enough. Yea, poor me. Anyhow, I got back in a few months ago, and now at the receiving end. I had a lot of PMs asking me about shipping, and obviously wasn't plugged into RC when I didn't have a tank. I don't know if anyone ever did a separate post of there are better ways... from getting a few fish orders, I'd say not much changed in 3 yrs.
|
Thread Tools | |
|
|