|
07/23/2015, 10:01 PM | #1 |
Registered Member
Join Date: May 2015
Location: Waco, TX
Posts: 417
|
Alteration to the Avast ATO
Can I cut the clear pressure sensor tube that is placed in the water? I would like to trim it down to have a lower profile as I have a wooden canopy that closes over the tank?
Also the sensor tubing is a little rigid, can I put 90degree elbows in or will this wreak too much havoc with the sensor? Thanks in advance!! Works great with the apex controller.
__________________
"The terrible thing, the almost impossible thing, is to hand over your whole self; all your wishes and precautions; to Christ." -C.S. Lewis (Mere Christianity) Current Tank Info: Currently Rebuilding |
07/24/2015, 09:05 AM | #2 |
Registered Member
Join Date: May 2015
Location: Waco, TX
Posts: 417
|
Anyone...
__________________
"The terrible thing, the almost impossible thing, is to hand over your whole self; all your wishes and precautions; to Christ." -C.S. Lewis (Mere Christianity) Current Tank Info: Currently Rebuilding |
07/26/2015, 10:13 PM | #3 |
Registered Member
Join Date: Mar 2013
Posts: 419
|
you can cut the tube, i inquired about it back then
|
07/27/2015, 01:38 PM | #4 |
RC Sponsor
Join Date: Feb 2006
Location: Northern VA
Posts: 2,446
|
Yes, you can cut the acrylic sensor tube down to about an inch total length. 90 elbow john guest fittings are not a problem either
__________________
Dan Don't rush art, you get bad art. |
07/27/2015, 08:17 PM | #5 | |
Registered Member
Join Date: May 2015
Location: Waco, TX
Posts: 417
|
Awesome, I already did, just could not for the life of me see why it would be a big deal.
Quote:
__________________
"The terrible thing, the almost impossible thing, is to hand over your whole self; all your wishes and precautions; to Christ." -C.S. Lewis (Mere Christianity) Current Tank Info: Currently Rebuilding |
|
|
|