|
04/05/2012, 10:23 AM | #1 |
Registered Member
Join Date: Dec 2005
Location: Jackson Hole Wy
Posts: 3,430
|
wiring 4 plugs to 2 0n meanwels drivers...
Ok this is a simple task but wanted to get feedback before it do it...
so I got a controller and what to wire the incoming power from 4 plugs down to, two. to save on controllable switches... should be no problem right I just solder 2 + together and the two - together. so this way I power to meanwells ELN-60-48 on one power plug. |
04/05/2012, 11:16 AM | #2 |
Team RC Member
Join Date: Sep 2003
Location: NY
Posts: 17,749
|
Essentially this is correct, as long as you're not overloading the plug you use or the outlet (but with only two drivers on each plug I don't expect that to be an issue).
If you solder, be sure to cover with quality heatshrink.
__________________
Inconveniencing marine life since 1992 "It is my personal belief that reef aquaria should be thriving communities of biodiversity, representative of their wild counterparts, and not merely collections of pretty specimens growing on tidy clean rock shelves covered in purple coralline algae." (Eric Borneman) |
04/05/2012, 11:45 AM | #3 |
Registered Member
Join Date: Dec 2005
Location: Jackson Hole Wy
Posts: 3,430
|
yes I have become a big fan of heat shrink.
|
|
|